skip to Main Content
86-0769-33365786 info@otschina.com.cn
Double Wings Drop Test Machine

Description Of The Wings Drop Test Machine

Double Wings drop test machine is mainly used to assess the package in the actual transport, loading and unloading process by the impact of the impact of the impact of packaging in the handling process of impact resistance and packaging design rationality.

Double Wings drop test machine Advantages:
The machine can be free to drop the surface of the package, the angle, the edge of the test, equipped with a high degree of display and the use of high degree of decoder decoder, which can accurately give the product drop height, and the default drop height error does not exceed 2% or 10mm. Kunshan Haida equipment combined with single-wing drop machine new research and development, using single-arm double-column structure, with electric reset, electric control drop and electric lift device, easy to use; unique hydraulic buffer device greatly improved machine life, And security. Single arm set, can easily place the product, drop angle impact surface and the floor plane angle error is less than or equal to 5 degrees. In the case of

Double Wings fall test machine Disadvantages:
Double Wings drop test machine every test is completed, the drop arm should be dropped; new machine to the plant after the completion of the installation, the need to slip in the round rod at the appropriate low concentration of oil.
If the oil time is too long there is too much dust Please reduce the machine to a low, wipe the previous oil, heavy machine oil.
Dropping machine is the impact of mechanical equipment, the new machine is used more than 500 times, the screws should be tightened in order to avoid a failure; test machine lift shaft and chain to be regularly added lubricants.
Gear reducer every six months to change the oil once; non-working should cut off all the power to ensure that the lift shaft clean.

Double Wings drop test machine Note and maintenance:
1, the test machine shell must be grounded, otherwise there is danger of electric shock;
2, the power into the line should be connected with the same capacity with leakage protection of the air switch and contactor, so that when the emergency cut off the power immediately;
3, the machine is running, do not touch the control panel in addition to other parts, to prevent abrasions or crush;
4, if you want to move the machine, be sure to cut off the power, the cooling 5 minutes and then operate.
5, the new machine to the factory after the completion of the installation, to be in the sliding round rod at the appropriate low concentration of oil, is strictly prohibited to join the anti-rust oil or high concentration of oil and the backlog with corrosive oil.
6, if the oil for a long time there is too much dust, please reduce the machine to a low, wipe the previous oil, and then re-oil; regularly in the machine transmission parts filling lubricants;
7, drop machine is the impact of mechanical equipment, the new machine used more than 500 times, the need to tighten the screws to avoid failure.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top