skip to Main Content
86-0769-33365786 info@otschina.com.cn
3

Maintenance of Tension Machine Control System

1.Check regularly whether the connecting wire of the back panel of the controller is in good contact. If it is loose, fasten it in time
2.If there is a longer period of time after the test without the machine, turn off the controller and the computer;
3.The interface on the controller is one-to-one correspondence, the wrong interface may cause damage to the equipment;
4.The interface on the controller is one-to-one correspondence, the wrong interface may cause damage to the equipment;
5.According to the use of the machine and the service life of the oil, regularly replace the oil filter and filter core, replace the hydraulic oil, regularly check the main engine and oil source to see if there is any oil leakage, if there is any oil leakage, replace the seal ring or combination gasket in time.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top